#Zmodeler 3 tutorial Patch

I load the small gas station prefab to show you what we shall deal with. Also, a 'Custom mesh colors' option is very preferable, so imported prefab splines will have different colors initially. Otherwise these options might be inaccessible. Once you switch it to 'SCS Compatibility' and restart ZModeler, certain options will get a meaningful ETS2-specific names in ZModeler. The suggested value is 2.5 for arrows.Р”Р„nother very important option you should set is the Compatibility for ZModeler. The size of an arrow is specified in ZModeler units and should be pretty big for prefab editing, so arrows are clearly seen. It will draw spline direction arrow, so you can easily say which direction spline goes. And one more handy option is 'Draw direction arrow'. It's easier when you see points location all the time. Spline detalization is not used when exporting prefab model, but it might be easier to deal with spline curves in ZModeler with constant detalization value.Р”Р„lso, enable 'Always draw points' option there to force ZModeler draw spline control points as dots even when you work on objects level. You should disable 'Automatic detalization' there, so all spline segments will have a predefined detalization value. Open it's Configuration window, locate General properties, expand Splines branch. Since prefabs include paths and routes and these are implemented in ZModeler as splines, you should configure ZModeler to work with ETS2 and splines properly. ZModeler3 allows you to edit and create new prefabs for ETS2. Using traffic light profile is preferable, as all other options can be omitted, so you can configure and refine options on traffic lights by altering their profile, instead of updating all affected prefabs.Р”В®TS2 Prefab editing including AI lanes, service points, navigation paths.

Traffic light profile is specified in traffic light name (before it's index in braces).

Some options were renamed, while their meaning remains the same. Several AI behavior changes applies to some options.

AI lanes intersections are generated on export, using ID value as priority on a given lane.

#Zmodeler 3 tutorial Patch

The summary of changes relevant to patch 1.9 as follows:.

in pre-1.9 exports, and as Option A is used to specify 'A' behavior.

This can be considered as Option A is used to specify 'A' behavior. 'B' behavior is not used, 'C' behavior applies. Option A is used to specify 'A' behavior. In case of replacing of description, only last term is considered obsolete. If an extended information is specified, it can either extended previous description, or replace previous term when '(Obsolete)' is specified in the beginning. If the only explanation marked states Obsolete, consider an entire description as obsolete, so it's no longer applies. Such an information is populated with an additional explanation highlighted in bright blue color. ETS2 AI was remastered in version 1.9 and higher, so some information in this guide is incorrect or obsolete.